Tails Doll papercraft

Hiya !

This is the template for the Tails Doll cubee. It's only 1 page and you can tell I really crammed everything in to fit !

Some notes:
The head antenna (long line with a red jewel) is really thin and finnicky. I recommend cutting it out with an xacto knife. I had no trouble with that, so long as you cut along the line and are patient, but I am not too sure the same can be said with scissors. If worse comes to worst, I'll upload one with a thicker antenna if it's too much of a hassle for people.

I didn't specify a place to put the antenna, so just put it anywhere you like. I suggest you cut a slit somewhere behind his bangs, but go on what you like. To make it easier to push into the slit, wobble around the xacto knife in your slit a little bit and keep trying to fit the antenna in like you're threading a needle. This is especially recommended if you decide to glue on the optional piece to the back of the antenna since this will make it slightly fatter (but more durable !).

The tails get weighed down severely if you decide to glue on the optional piece. If you plan to go that route, I recommend you glue the tab into slot G so that the tails don't fall out. If you choose not to glue on the extra tail piece, it should probably be fine.

The ears and bangs (top bang only) can be cut out along their outlines so that they pop out.

Everything else should be fine. Questions, suggestions and feedback are always welcome ! I'm a rookie papercrafter making crafts of my fave characters that don't have many papercrafts, so there might be mistakes or things that may be clear to me but not to everybody. ^u^; Don't kill the poor doll because of the antenna and have fun ! xD